Lithium battery equipment host cleaning and installation analysis

The detailed contents of the battery equipment finishing host are as follows: ①Remove the battery equipment die head and start finishing; ②Remove the machine head and filter plate; scrape clean the material on the filter plate and machine head with a scraper; then use the cleaning ball to add a small amount of white Clean the materials in the head with mineral oil; ③Remove the vacuum chamber, vacuum gland and glass fiber port gland, and scrape the materials on the vacuum chamber, glass fiber port gland and vacuum gland with a scraper; Pry out the screw of the main machine with the standard clamp pry bar, ask for the assistance of the neighboring machine and the machine cleaning personnel (the small machine screw must be 4 people, the large machine screw must be 6-8 people), use the special clamping bar to lift the screw and send it to Grind the room and pull the screw to be replaced to the machine table. ⑤Start to wipe the screw barrel with a cloth; increase the temperature by about 20°C, cover the feeding port, glass fiber port and vacuum port with a cover plate, lift the exhaust pipe, and be aware of the exhaust pipe from catching fire. ⑥ Use a screw barrel grinder to polish the screw barrel clean; then wipe the screw barrel clean with a cloth. (The inside of the barrel glows brightly) ⑦ Take the die, filter plate, vacuum chamber, vacuum gland, and fiberglass mouth gland to the isolation area and polish it cleanly. ⑧Check whether the vacuum system of the battery equipment is intact. 3. The detailed content of the battery equipment host device is as follows, but it is different from the battery automation equipment process. ① Clean the screw to be installed, and check whether the battery equipment is damaged or other abnormalities; find the security device to fix the screw. ②Install the polished glass fiber mouth cover, vacuum cover, vacuum chamber and vacuum gauge, and check whether the vacuum meets the process requirements. ③Wash the machine with PP+glass fiber or long-fiber washing machine. After washing, it must be washed with good washing machine materials (such as: PP, PS and other washing materials). ④ Install the filter plate, machine head, and die head of the battery equipment; pay attention to whether the filter plate, machine head, and die head are smooth or not, and whether to use raw tape; it is forbidden to use iron to strike when loading and unloading the machine head and die head. Use non-standard automation equipment accessory copper rods to strike; when screwing the screws, tighten the screws at the corners, and tighten them diagonally after the temperature reaches the process setting value to beware of leakage. Disclaimer: Some pictures and content of the articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous: Analysis of 18650 lithium battery and lithium battery pack repair