How to charge the lithium iron phosphate battery correctly?

The correct charging method for lithium iron phosphate battery Although the lithium iron phosphate battery has a design-limited voltage, it is also equipped with a protection board to protect the lithium battery pack from overcharging. But in order to make the life of the lithium battery pack longer, the correct charging method is also very important. Charge the new battery because it was previously stored in inventory. In order not to lose the battery, when the lithium battery reaches the user, it is usually in a dormant state and the capacity is lower than the normal value. At this time, activation is generally required, and the battery pack can be activated and normal capacity can be restored after 35 normal charge-discharge cycles. Due to the characteristics of the lithium battery itself, it is determined that it has almost no memory effect. Therefore, users do not need special methods and equipment during the activation process of the new lithium battery pack. It is best to use the standard method of charging from the beginning, which is a natural activation method. Charging in normal use When the machine battery is too low prompt, you should try to start charging as soon as possible. Under normal circumstances, the battery should be charged in accordance with the principle of recharging when the remaining battery power is used up. When it is necessary to charge to cope with the important event that is expected to be busy with the upcoming use, even when the battery has a lot of remaining power, it can be charged in advance, because it does not really lose the life of one charge cycle, which is only 0.x times. , And often this x will be very small. Disclaimer: Some pictures and content of articles published on this site are from the Internet. If there is any infringement, please contact to delete it.