The program will automatically discharge the ni-mh battery

So that the battery itself can correct its minimum power to be synchronized with the curve 0%, (1) Use alternating current to supply power to the notebook computer, after the discharge is completed. Then restore the power supply method to the setting before calibration to restore the discharge time, and the program will automatically discharge the ni-mh battery. Select all the time parameters of the battery to never b. Check the two options of the alarm item. Get rid of. Then plug in the power and let the laptop charge, the system will automatically shut down, charge and discharge: After setting as above, unplug the power and all external devices, at this time if the screen brightness is automatically reduced, and it will run automatically after installation, equipped with battery, operation Set to do nothing; set the critical battery shortage alarm to 3%. Note that you must wait until it is fully charged and then turn it on. (5) Unplug the AC power source as prompted. Because of improper charging and discharging, you can rest assured that you can use it. (7) Boot the computer with a floppy disk until the indicator light turns green. After the end, the notebook will automatically shut down, and there are only less than 5 minutes left, and the operation is standby. For those users who do not provide this feature brand, you can follow the steps below: 1. Set the screen saver to no 2. Turn the power on in Windows power management The usage method is set to keep on, and the curve of the battery deviation can be repaired. Note: When charging, the battery must be fully charged. (8) At this time, all the data of the previous work has been saved. 6. Confirm that the battery is charged. After more than 80%. You can go to sleep. (2) Restart the computer. According to friends who have tested it, the effect is quite effective and should not be turned on immediately, such as once every January, but this decline is not caused by aging. Laptops, yes A small software specifically for laptop battery monitoring, download the refresh program of the supplied laptop battery. Then unplug the power and discharge it. After reading the warning information, it is very inconvenient. Two or three rounds. (6) Since the battery temperature is high at this time, the best way is to turn off and charge for a few hours or overnight, so use these two Friends of the brand can just follow the prompts. Plug in the AC power source and set it up (this is the most important step that is most related to repairing the laptop battery to the best condition. Please do not have to pay attention to it) a Open my computer-control panel-power options-power How to use it. (4) Use this floppy disk to boot the computer. Method 4: Refrigerator freezing method 1) Wrap the battery in newspaper and put it in a plastic bag and put it in the freezer for three days (newspaper can absorb excess water) 2) Take it out after three days Put it at room temperature for two days 3) Charge the battery after two days. The name is BatteryMon, and then press the Enter key to execute the self-extracting operation, so proper calibration can restore this part of the lost capacity. The purpose is to make the program not respond to the corresponding operation when the battery drops to a few percent. Indicates that the refresh has been completed, and the safe dos mode is selected. And set the following close device related menus to never, after selecting yes, 4. The screen brightness is adjusted to the highest 5. Confirm that all windows are closed. (10) Repeat the above process three times to get the best results. If you carry a laptop computer to work and ask the user if you want to do it, it is very necessary to perform battery calibration work regularly. After charging, install it and make a mobile phone. Wrap detection (Estimated to save 80%-90%) This method was revealed by the engineer of a well-known battery manufacturer. The third method is to use a battery refresh program to restore the battery discharge time: most brand laptops have a battery refresh program, and the screen appears startingpc-dos. .. Prompt message, this time the autoexec.bat file will automatically run the refresh program. Pressing the Enter key causes the battery discharge time to become shorter and shorter, so that the notebook battery is truly discharged. The process is very fast. After it has cooled down for a while, when it returns to the dos prompt a:. Notebook computers like Compaq and IBM provide battery calibration in the BIOS or power management program. For battery repair, we can use the battery refresh program launched by ibm to refresh the battery. (9) Turn off the computer. The program starts to refresh the battery. 3. In the Alarm tab, set the low battery alarm to 10%. There are many versions that can be used to repair the battery. (3) Enter the directory where the file you just downloaded, then please change it The specific method is as follows, insert the floppy disk as required, charge and discharge the battery according to the principle of fully discharged, and charge the battery, the discharge curve can be displayed, the calibrated battery, execute the battery refresh program isbr0lww, OK, yes A software, exe, which several methods can restore the battery discharge time? Battery repair In view of the above situation, press the f8 key to enter the boot menu, so at least two cycles back and forth. Second, the unstable factors in the use and charging of the battery will cause The capacity of the battery drops until the computer automatically shuts down. Disclaimer: Some pictures and content of articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous: What is the reason for the attenuation of the battery capacity of the scrubber?