How to charge and activate camera lithium battery

Camera Lithium Battery Charging Activation Mode The camera’s lithium battery cannot be charged, so it is either broken or locked. Charging with a non-original charger will lock the power, especially the inferior all-round charging quality. The following method can be used to try to remove the power lock. If it fails, the battery will be discarded and a new one is required: 1) Regarding the battery whose voltage is too high due to overcharging, you can use 10-15 ohm positive pole to connect the positive and negative poles of the battery to discharge. The standard 1800mAHPSP battery has a normal operating current of 400~700mA, a voltage of 36V, and a 10 ohm resistor for discharge. The current is 360mA, which is very safe and will not damage the battery due to high current discharge. The time for full discharge is about 4 hours. After discharging for more than 10 minutes, you can put it in the PSP to see if it is unlocked. 2) For users who are locked out due to over-discharge and unable to charge in the PSP, you can use the pedestal charger to charge first. There is no need to charge it. After it is estimated that 50% of the power is charged, the charging should be stopped and the voltage measured. Take the two wires, stand apart, insert the +- north pole and south pole slots, and the two wires at the other end will quickly hit, that is, a short circuit, usually you can see a small fire. The capital of consumer electronics products is not sensitive (relatively), but the real volumetric energy density is too high, so lithium batteries are the most expensive lithium cobalt oxide to dominate the world. These years, the capital of ternary batteries is low, and there is also a part of a shopping center. (As an acquaintance described: now it is more of a part of the power bank category). In the future, high-capacity energy density must still be the mainstream> lithium cobalt oxide for lithium batteries will not change. If flexible battery skills are indeed developed, or demand scenarios are added, then there will be some new developments and the use of solid/flexible skills. Metal hydrogen/air/fuel power batteries will basically only be used to subdivide categories similar to external mobile emergency power supplies. If lithium sulfur can be done well, it may be more useful for places with low volumetric energy density. Supercapacitors have ultra-low energy. Density, but also has the advantage of fast charging) will also find that there are only a few special categories, and basically no other skills are often used in this direction. Disclaimer: Some pictures and content of the articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous: Characteristics of aluminum-air batteries