Precautions for using batteries

Precautions for using batteries 1. Prevent direct contact between the battery and the metal container, and choose acid-proof and heat-resistant materials, otherwise it will cause smoke or burning. 2. Use the designated charger to charge under the designated conditions, otherwise it may cause the battery to overheat, leak, leak, burn out or crack. 3. Do not put the battery device in a sealed device, otherwise the device may be disassembled. 4. When the battery is used in medical equipment, please refer to the standby power supply outside the main power supply of the equipment, otherwise the main power supply failure will cause damage. 5. Keep the battery away from the spark device, otherwise the spark may cause the battery to smoke or split. 6. Do not put the battery near a heat source (such as a transformer), otherwise it will cause the battery to overheat, leak, burn out or crack. 7. When using more than one battery, please make sure that the connection between the batteries is correct and the connection with the charger or load is correct. Otherwise, the battery will split, burn or be damaged, and in some cases, people will be injured. 8. Be careful not to let the battery hit your feet. 9. The specific operation method of the battery is as follows. Exceeding this plan may cause damage to the battery. The battery normal operation plan is: 77. After F(25℃) battery is discharged (installed on the device): 5. F-122. After charging, F (-15°C to 50°C): 32. F-104. 10. Do not put the battery installed on the locomotive in front of the furnace or make a fire under high temperature and direct sunlight, otherwise it may cause the battery to leak, catch fire or crack. 11. Do not use the battery in dusty places, it may cause a short circuit of the battery. When using the battery in a dusty environment, check the battery regularly. Battery maintenance 1. First, connect the battery leads correctly to prevent short-circuiting. The battery should be placed close to the generator set, so that the battery connection line will not be too long. When the battery is connected to the generator, first connect the positive pole and then the negative pole. When the battery is loaded or stopped, disconnect it in time to prevent the battery from short-circuiting. 2. Secondly, do a good job of daily battery inspection. Regularly check the battery, including the battery terminal voltage; the density, temperature and height of the electrolyte in the battery; pay attention to whether the battery connection meets the standard connection; check whether the battery is corroded; do regular discharge tests, etc. And so on, these daily operations are necessary. 3. After all, it is a basic operation to pay special attention to the battery charging operation. It should be charged in an environment with good ventilation, no rain, snow, sparks, or open flame; it is best to use the original charger when charging; connect correctly when charging Good wire; charge with reasonable current; when the battery is charging, when the temperature is higher than 45℃, the charging should be stopped and heat dissipation treatment should be carried out. The maintenance of the battery is very important, and you must pay attention to it in daily use. Disclaimer: Some pictures and content of articles published on this site are from the Internet. If there is any infringement, please contact to delete.