EV battery

How to assemble lithium batteries for electric vehicles?

by：Vglory 2021-03-27

In the process of disassembling the battery, check the quality of all connections. At the same time, check whether the fuse holder, charging socket, and the contact of the lead wire of the lithium battery of the electric vehicle are normal and reliable, and tighten all the connections. The ones to be replaced should be replaced, and the reliability should be focused on, and the unreliable ones should be replaced. Step 2: Install the lithium battery of the electric vehicle according to the instructions in the battery assembly box. In fact, most of the batteries inside the battery box are connected in series. Use a copper wire of not less than one square to connect each battery in series with a soldering iron, and finally there are two output terminals positive and negative. , Welded on the two pieces of the output socket, be careful not to connect them backwards, and be sure to correspond to the positive and negative poles on the charger. Otherwise, the result will be serious. Step 3: After installing the lithium battery of the electric vehicle, use a multimeter to measure the voltage of the battery output port. The actual voltage of the battery is 2~5V higher than the standard voltage, and it can be put into normal operation after it is normal. Disclaimer: Some pictures and content of articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous: Analysis of the characteristics of ceramic-coated lithium battery separators

Custom message