What should be paid attention to in the planning of lithium battery casing?

1. Pole piece connection: It is recommended to use ultrasonic or spot welding welding method, and the lithium battery shell plan should make the pole piece free from external force. 2. The soldering time should not exceed 3 seconds, and the number of times should not exceed 5 times. The next soldering can only be performed after the pole pieces have cooled. 3. It is forbidden to heat the battery directly, it will damage the battery if the temperature is higher than 100℃. 4. Fixation of the battery: the side with the largest area of u200bu200bthe battery should be fixed on the casing, and the battery cannot be loose after the installation. 5. Shell toughness: The lithium battery shell should have sufficient mechanical strength to protect the battery from mechanical impact. 6. The welding temperature of ferrochrome must be controllable and anti-static, and the temperature should not exceed 350°C. What should be paid attention to when planning the lithium battery casing? Today, Hongfa’s technical staff analyzed the precautions for us in the planning of the lithium battery casing. The above six points are important. The lithium battery casing is very important for the battery. Therefore, the planning of the lithium battery casing is extremely important for the battery, and the method must be mastered when planning. Disclaimer: Some pictures and content of articles published on this site are from the Internet. If there is any infringement, please contact to delete.