What matters should be paid attention to for 18650 battery film machine equipment

1. When the 18650 battery film machine is turned on, first check whether the actuators of the equipment are in the initial position, admit that there is no other sundries on the equipment, and then turn on the air source, and admit that the air source pressure is 0.5～0.6Mpa. Then turn on the power operation control program: 2. Turn off the power and air source when the equipment is out of work after work: 3. Turn off the power and air source when repairing, maintaining and maintaining the equipment: 4. Disconnect the batteries to be sorted When loading the loading box, try to ensure that the positive and negative directions of all batteries are in the same direction: when the battery in the receiving box is almost full, remove the batteries in time: 5. Do not put your hands in when the machine is running In the battery sorting track, so as not to pinch fingers: 6. When the equipment is running abnormally or stops for no reason, press the emergency stop button first, and then check the abnormal condition of the equipment. After the fault is eliminated, release the emergency stop button. Return the manipulator to the original point and the system is in a suspended state, and then press the start green button to make the system resume active operation. If the system fails to operate, press the system reset button to resume normal operation. 7. When the sorting of a certain type of battery is complete and there is no material alarm, you can press and hold the green button for 3 seconds to empty the material, or after waiting for 30 seconds, the system will automatically enter the finishing mode and automatically sort the remaining materials to the trough. After the sorting, the equipment will be out of condition, please load the material. 8. Before each operation of the 18650 battery film machine, the batteries on the sorting manipulator should be emptied, press the system reset button to make the equipment enter the initial state, and then press the run button: 9. Make sure that the 18650 battery film machine is ready to be sorted The positive and negative electrodes of the battery should be cleaned, and the test probe should be guarded against dust and other debris to ensure the accuracy of the measurement data: 10. To ensure the measurement accuracy, it is recommended to clean the probe with alcohol every 4 hours under normal production conditions. Replace the probe once a month: 11. To ensure the high-precision measurement of the detector, please reset and calibrate the detector on time. Disclaimer: Some pictures and content of the articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous post: Comparative analysis of car batteries and electric vehicle batteries