What is the important difference between smart batteries and non-smart batteries

1. View battery information. Non-smart batteries: Only third-party modules can be used to collect internal voltages. When operating drones, model friends can only judge the duration of battery power supply based on the battery voltage. Smart battery: In addition to the ability to judge the battery power through the LED lights, it is important because the internal information of the battery can be imported into the APP software through the protocol port to observe the battery information in time, such as the true capacity of the battery, the remaining capacity, and the voltage of a single battery. , Cycle times, over-discharge times, etc., these data will be stored in the memory chip by the smart management board inside, and the player can grasp all the battery data at a glance through the battery information transmitted by the mobile phone APP. 2. Protection function of non-smart battery: the previous B6 charger appeared because the battery itself did not have charging protection and equalization function, so as to prevent battery overshoot by controlling the charger. Smart battery: the smart management board is a protection for the battery itself The intelligent management board of the intelligent battery will automatically detect the battery voltage. Once it exceeds the safe range value, it will automatically cut off the current. While charging, the intelligent management board will also balance the battery cells. At the same time, the mold friend is in operation. , Once there is a low voltage, the management version will also immediately send an alarm message to the receiving end, prompting that the voltage is insufficient, and immediately return to home and other information. 3. Idle protection for non-smart batteries: After non-smart batteries are idle, the battery should be charged and discharged regularly to slow down the decline of battery performance. Many negligent model friends will cause the battery to break for no reason. Smart battery: The smart battery itself will detect its own situation. If it detects that the battery has not been discharged within 10 days, the management board will automatically start the sleep mode, which greatly reduces the self-consumption of the smart board, and at the same time allows the battery to discharge to 65% of electricity. 4. Self-check function. Non-smart battery: Non-smart battery intelligence judges whether the battery is in a normal state of health through human operation, multimeter measurement and other means. Smart battery: The smart management board detects battery information in real time to determine whether the battery is in a normal state. If an abnormality (short circuit, low voltage, etc.) is detected in the battery, it will automatically tell the user that the abnormal state is caused by different forms of LED flashing modes s reason. Disclaimer: Some pictures and content of the articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous: Battery pack assembly process and characteristics introduction