What is the general battery activation process?

Generally, the battery has the following activation process: Activation process 1: The lithium battery that has just been used generally has remaining power, so do not charge it at this time. Put the battery into the product and use it normally until the battery is too low to turn on at all. Activation process 2: The first time you charge, it is best to use the original charger to charge, and it is better to turn off the charge. Many people do not turn off the charge for the convenience of use, which is not conducive to activating the lithium battery capacity. And remind everyone to continue charging for more than 12 hours and less than 15 hours. During the period, if the prompt is full, don't bother to unplug it, let it keep charging all the time! Activation process 3: After the first full charge, if it is used normally until it cannot be turned on. You can press the second procedure to continue the operation! Activation process four: complete discharge, complete charge (ie repeat process two and process three) repeated three times. At this time, the battery is activated successfully and can reach the best capacity state. Note: Lithium batteries are often activated at the factory, so do not activate the buyer again. It is recommended not to use universal chargers during the activation period. If it reaches the normal period of use, the universal charger is unnecessary. Because the original charger is the most suitable. Universal charger, current unstable, does not necessarily match the voltage of the lithium battery, it may accelerate the aging of the lithium battery. Disclaimer: Some pictures and content of articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous post: What are the reasons for the aging test of lithium battery packs?