What are the ways to use lithium battery electrolyte?

Lithium battery electrolyte usage method 1. Before use, the processing personnel must inform the injection process QC to detect the water content of the electrolyte, and the processing can be performed after the test is qualified. 2. When replenishing the electrolyte from the electrolyte tank to the buffer tank, two people (A and B) work together. A first opens the buffer tank valve 1, as shown in Figure 1, and B then opens the SP quick valve 2, as shown in Figure 2, and then Observe the electrolyte level in the transparent tube above the buffer tank. It is required to close valve 2 and then close valve 1 when the electrolyte height does not exceed the uppermost end of the plastic tube. 3. When the pressure in the electrolyte barrel of the lithium battery is lower than 0.01Mpa or the electrolyte cannot be pressed out, it is said that nitrogen should be added to the electrolyte barrel, and the nitrogen filling pressure should not exceed 0.2Mpa (the gas injection time is generally 7-10S) , The pressure gauge on the left shows. When switching the SP quick connector after the electrolyte is used up, the quick connector must be cleaned with DMC first, and then dried or dried after cleaning with absolute alcohol. 4. Before shift shifts, all valves in the buffer tank must be closed and sealed for storage; when the electrolysis test in the buffer tank fails, the electrolyte in the tank needs to be drained, and a special container is used to hold the discharged electrolyte. Alkali neutralization treatment. 5. After the electrolyte of the lithium battery is used up, the empty drum shall be marked and recycled. 6. Lithium battery electrolyte should be stored in a cool place, the temperature is less than 25℃, away from fire and heat sources. Disclaimer: Some pictures and content of articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous article: What are the application markets for lithium batteries?