What are the ways to add water to lead-acid batteries?

How to add water to lead-acid batteries: Replenishing lead-acid batteries for electric bicycles should be carried out in accordance with the following operating procedures: ①Preparation. Prepare electrolyte with distilled water and pure acid, the ratio is 500mL distilled water and 0.5mL pure sulfuric acid. Prepare a standard rubber exhaust valve as a spare. The required tools are screwdriver straw (can be replaced by disposable needle tube) transparent polyethylene tube (the diameter of which should be suitable for the suction port of the straw or needle tube) ABS glue. ②Pry open the cover plate above the lead-acid battery along the vent hole. The covers of some lead-acid batteries are glued with ABS glue, and the covers of some lead-acid batteries are connected with buckles. Be careful not to damage the cover when you pry the cover off. At this time, the rubber caps of the 6 exhaust valves can be seen. ③Open the rubber cap to expose the vent hole, through the vent hole you can see the inside of the lead-acid battery. The exhaust valve of some lead-acid batteries can be unscrewed, and there are some fillers around the rubber caps of some lead-acid batteries. Take care to remove the fillers. ④Suck the prepared electrolyte with a straw and inject it from the exhaust hole. The electrolyte should cover exactly 1mm of the plate. ⑤ Cover the vent hole of the lead-acid battery filled with electrolyte with a breathable shield to prevent dust from falling into the vent hole. Stand still for 24 hours, and observe whether there is flowing electrolyte (free acid) inside the vent. If not, replenish the electrolyte. Disclaimer: Some pictures and content of articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous article: What are the battery charging techniques?