What are the reasons for the bulge of lead-acid batteries?

First of all, beware of sparks during the use of the battery, which requires the battery to be installed firmly during use, the connection between the wire joint and the electric pile must be tightened, and the welding quality of the plate assembly must be ensured during overhaul. Secondly, in order to make the gas that appears in the battery work to overflow from the vent hole of the filling port in time, so that the internal air pressure of the battery is not too high, usually the filling cap of the battery must be tightened and the vent hole is often cleared. Third, in order to guard against excessive discharge of the battery, when starting the vehicle with the starter, especially when starting the vehicle under low temperature conditions, the starter cannot be used continuously. When starting the vehicle in a cold car, the vehicle must be preheated. The combination time of the starter must not exceed 5-10s, and it must be started at an interval of 10s-15s. Fourth, when charging the storage battery, beware of excessive current or overcharging. For this reason, for the batteries that have been installed on the vehicle, the rated voltage of the generator must be adjusted; for the batteries that are charged in the charging room, the charging current and charging time must be controlled. Disclaimer: Some pictures and content of articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous: Analysis of the market price of ternary lithium battery materials