What are the installation specifications for UPS battery cabinets and battery racks?

UPS battery cabinet and battery rack installation specifications 1. Power distribution requirements Regarding the input and output wiring of the machine, the user electrician should connect it in advance and pull it to the installation site to reserve a certain length (generally reserve 1-1.5m long) , So that the machine can be installed smoothly after arrival. Regarding the installation by the factory, the user should make all preparations before the factory can dispatch personnel to set off. 2. Selection of input and output wire diameters The selection of the input and output wire diameters of the machine must not be lower than the national electricity safety standards. 3. Main points of wiring It is better to use multi-core flexible wire for all input and output copper core wires, which is convenient for users to wire and also conducive to machine wiring. The underground wiring of the input and output of the machine should be sheathed with metal material. Matters needing attention in the installation of UPS battery rack ●Using environment: UPS battery rack and EPS can not be placed in a humid, dirty, air-free environment; small UPS should not be directly stacked on the ground, and there should be cushions at the bottom to prevent Condensation in the wet machine in spring! Medium and large machines are best placed in a dedicated machine room. A good operating environment can greatly extend the service life of the machine and various loads of users. ●Ventilation/load-bearing safety: The machine should be placed so that the air inlet/outlet duct of the machine is not less than 30 cm away from the wall to facilitate the heat dissipation of the machine! The storage battery of the medium and large UPS long-duration models should also be considered for the floor load pressure. ●Lightning protection: Regarding UPS and EPS users in suburbs and open areas, due to the lack of high-rise buildings, their power transmission relies on overhead lines. Overhead lines are prone to lightning strikes during thunderstorms. Users should install special high-power at the input front of the machine. Lightning protectors can effectively prevent lightning damage to the equipment and user loads. Disclaimer: Some pictures and content of articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous: How to improve the energy density of the battery?