What are the equalizing charging methods for lithium batteries?

At present, the following methods are important to realize the equalization of the individual batteries in the series battery pack. 1. Add a parallel equalization circuit to each single battery of the battery pack to achieve the purpose of shunting. In this mode, when a battery reaches full charge first, the equalization device can prevent it from overcharging and convert the excess energy into heat energy to continue charging the undercharged battery. This method is simple, but it will cause energy loss and is not suitable for fast charging systems. 2. Before charging, each cell is discharged to the same level through the same load one by one, and then constant current charging is performed to ensure a more accurate equilibrium state between the cells. However, for battery packs, due to physical differences between individuals, it is difficult to achieve a completely consistent ideal effect after deep discharge of each cell. Even if the same effect is achieved after discharging, a new imbalance will appear during the charging process. 3. The single cells in the battery pack are tested and charged uniformly on time, in sequence, and individually. When charging the battery pack, it can be ensured that each battery in the battery pack will not be overcharged or over-discharged, thus ensuring that each battery in the battery pack is in a normal working state. 4. Using the time-sharing principle, through the control and switching of the switch components, the extra current flows into the battery with a relatively low voltage to achieve the purpose of balanced charging. This method is more efficient, but the control is more complicated. 5. Take the voltage parameters of each battery as the object of equalization to restore the voltage of each battery to the same level. During equalizing charging, the capacitor is alternately connected to two adjacent batteries through the control switch, receiving the charging of the high voltage battery, and then turning to the low voltage. The batteries are discharged until the voltages of the two batteries tend to be the same. This kind of equalization method better solves the problem of unbalanced battery pack voltage, but this method is mainly used in occasions with a small number of batteries. 6. The entire system is controlled by a single-chip microcomputer, and the single battery has an independent set of modules. The module manages the charging of each battery separately according to the set procedure, and automatically disconnects after charging is completed. Disclaimer: Some pictures and content of articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous article: What are the advantages of vanadium batteries compared with traditional lithium batteries?