UPS lead-acid battery electrolyte preparation method and matters

UPS lead-acid battery electrolyte preparation method (1) The container for preparing battery electrolyte should be acid-resistant glass ceramic, hard rubber or lead container (2) Full protection. When preparing the electrolyte, the operator must wear protective glasses, acid-proof gloves, rubber aprons and high-waist rubber boots to prevent burns. Once the sulfuric acid splashes on the clothes, they should be soaked with 10% soda solution (sodium carbonate) immediately, and then rinsed with water. (3) Preparation operation method. According to the required electrolyte, calculate the amount of distilled water and sulfuric acid based on the mixing ratio. (4) Measure out the calculated distilled water with a graduated cylinder and pour it into the acid-resistant capacity for preparing the electrolyte. (5) Measure out the required amount of sulfuric acid, slowly add it to the water, and continuously stir with a glass rod or a plastic rod to make the two mix evenly and quickly dissipate heat. (6) If the temperature of the prepared electrolyte is too high, it should be allowed to stand and cool to room temperature before it can be used. Precautions for UPS battery electrolyte configuration. Never pour water into concentrated sulfuric acid, because violent thermal exercise can easily cause sulfuric acid to splash and hurt people; rubber gloves, helmets, eyes and protective clothing must be worn during the preparation process; sulfuric acid must be splashed on the body. Rinse immediately with water. If it enters the eyes, you must consult a doctor after flushing; stir immediately after preparation to dissipate heat; do not use metal utensils for the preparation container and stirring rod; the temperature of the newly prepared solution is very high, do not immediately pour into the battery, wait until the temperature drops to 40°C Next, measure the concentration of the solution and adjust it to the standard value before adding it to the battery. Disclaimer: Some pictures and content of articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous post: What are the bottlenecks in the manufacture of lithium titanate materials, batteries and battery packs?