Is it hard to ride an electric bike? Check the following 7 points to try!

When you are riding an electric bicycle normally, if you feel that the car is heavy, electric and pedaling are strenuous, and the speed is slow, we call these phenomena the strenuous riding. Once you experience the situation that the more you ride the electric bicycle, the more difficult it is, it is likely to be caused by the following 7 reasons.　　 Failure reason 1: The tire is under-inflated or jogging, which increases the rolling friction between the tire and the ground.　　Exclusion method: replenish the tires with air. If it is jogging, the tires should be repaired after the inspection, and then inflated for riding.　　 Failure reason 2: The rim of the electric vehicle touches the brake shoe or other parts, causing friction.　　Removal method: ①install or adjust the wheel; ②adjust the brake shoe position.　　Fault cause 3: The frictional resistance between the front and rear bottom bracket rolling bearings is too large. Remedy: ①Tighten the front and rear bottom axles and loosen the shaft blocks that are too tight; ②If the friction resistance between the bottom axle and the rear axle is too large due to the chain being too tight, adjust the chain tightness; ③If it is caused by sand and oil pollution When the friction resistance of the front and rear bottom bracket is too large, clean it; ④ When the friction resistance of the rolling bearing parts is damaged, or the friction resistance is too large due to the loss of oil and ablation, replace the worn parts.　　 Failure reason 4: The friction resistance of the electric bicycle transmission system is too large.　　Removal method: ①Adjust the relevant parts of the transmission system so that the flywheel, sprocket and chain are on the same plane; ②eliminate the axial runout of the sprocket.　　 Failure reason 5: The wheels are soft.　　Exclusion method: Check the spoke tension, if not enough, tighten the spoke.　　 Failure reason 6: The chain is too tight.　　The troubleshooting method is very simple, just adjust the front and rear position of the rear wheel axle; 　　Fault reason 7: The front and rear axle blocks and the bottom bracket parts are too tight or the parts are worn.　　Once this happens, loosen the fasteners or replace or repair the worn parts; 　　The above is the reason why it is easy to ride an electric bicycle at 7 o'clock. Everyone must pay attention to regular inspections when using electric bicycles on a daily basis, so that there will be no 'half riding, you will lose the chain' situation.　　 In addition, when choosing batteries, try to choose high-quality, well-reputed brand batteries, such as batteries. The battery quality is very good, the service is also good, the sales, customer service, technical support, maintenance and other aspects are well established, which can provide consumers with better after-sales service. Previous: 5 major faults and causes of electric vehicle batteries!