Analyze the use of lithium battery dehumidifier

The use of lithium battery dehumidifiers The wet environment in life will affect people's health, and the wet environment in industry will involve safety issues. Therefore, in the workshop environment, it is necessary to use a dehumidifier. Only by purchasing a high-quality dehumidifier can the humidity in the workshop be reduced and the expected effect can be achieved. The following article explains the brand dehumidifier for you. When the air is cooled below the dew point temperature of the lithium battery dehumidifier, the moisture in the air will condense into water. The condensed water is removed and reheated to obtain low-humidity air. The cooling source of the air can be refrigerant, ice water or salt water of the refrigerator. Features: When the surface temperature of the cooling coil is lower than 0℃, the condensed water will freeze on the surface of the coil, reducing the cooling efficiency and dehumidification effect. Therefore, stable humidity cannot be obtained. Generally speaking, the cooling and dehumidification limit at the dew point temperature is above 0°C. If the equipment is large, it will increase power consumption and increase operating costs. The air is compressed and then cooled, and the moisture in the air condenses into water. The condensed water is removed and reheated to obtain low-humidity air. Features: Suitable for dehumidification with small air volume and low dew point; high cost of compression power; suitable for occasions where high pressure and a small amount of dehumidified air are required for instrumentation and control. The solid adsorbent (such as silica gel, on the screen, active vaporized aluminum, zeolite, etc.) is used as a fixed layer, packed tower (cone), using two or more towers, towers, towers that absorb moisture in the air , Another tower is regenerated. After the time is set, the tower and the air circuit are changed to exchange the moisture absorption and regeneration effects, so intermittent dehumidification air can occur. Features: Using solid adsorbents, low dehumidification air can be obtained; dehumidification and regeneration are converted within a solid time period, so stable dehumidification air cannot be continuously obtained. The adsorbent should be replaced regularly; the pressure loss of the equipment is large; the regeneration temperature is high; the gas path is fully enclosed and can be used for the dehumidification of non-air gases. The adsorbent uses lithium chloride solution, which is mainly composed of a dehumidifier, a regenerator and a circulating pump. When the air contacts the spray adsorbent in the dehumidifier, the moisture in the air is absorbed by the solution and dehumidified, and then the cooling coil cools the condensation and absorption heat that occurs. The water absorbing solution is pumped to the regenerator through the solution circulation pump, and the regenerating air heated by the heating coil comes into contact with it. The water in the solution evaporates and exits the room with the regeneration air. Therefore, the concentration of the solution in the regenerator is increased and then sent to the dehumidifier by the circulating pump. Features: continuous dehumidification and regeneration, stable dehumidified air can be obtained; since the solution is the intersection of mist and air, the solution should be prevented from being carried out or flying away; because lithium chloride will be different under different liquid concentrations and temperatures Spots precipitate or crystallize, so it is necessary to control the concentration of the solution according to the characteristics of the solution, otherwise it is easy to cause damage to the circulating pump or blockage of the nozzle. The solution should be replenished and replaced regularly; the air can be disinfected and cleaned; high installation costs and high maintenance costs. Workshop dehumidifier is a commonly used dehumidifier, which can improve the humid environment well. When buying a dehumidifier, you should pay attention to comparing the effects and effects of these machines, and choose the one with the most cost-effective one. I hope that the above articles can be helpful to you. Friends who want to learn more can continue to study on this website. Disclaimer: Some pictures and content of the articles published on this site are from the Internet. If there is any infringement, please contact to delete. Previous article: How to calculate the lithium battery parameters?