Analysis of installation and wiring methods for lithium battery packs for solar street lights

1. Wiring method of lithium battery pack and LED light, load output: positive and negative (red wire represents positive electrode, black wire represents negative electrode); the positive electrode is connected to the positive electrode of the LED light, and the negative electrode is connected to the negative electrode of the LED light. 2. Wiring method of lithium battery pack and solar panel, solar input: positive and negative (red wire represents positive electrode, black wire represents negative electrode); the positive electrode is connected to the positive electrode of the solar panel, and the negative electrode is connected to the negative electrode of the solar panel. Lithium battery pack installation steps 1. Connect all the connecting wires and check if the charging indicator (green light G) is on normally. 2. If it is on normally, unplug the solar input after 10 seconds, and the load output LED light will be on normally. 3. Reconnect the solar input, and the load output LED will go out after 10 seconds. 4. After all the above steps are completed, the solar street light can be used normally. Statement: Some pictures and content of the articles published on this site are from the Internet. If there is any infringement, please contact to delete the previous article: Playing with the phone while charging will cause damage to the battery Does it hurt a lot?